I’ll start with the pros first. The led themselves are pretty bright and I option them to come with a connector already installed and it was super simple to install which was nice and it just plugs right into the factory harness off the old oem running boards. And it also works like the lights off the running board so when you unlock they turn on or if the door is open they turn on. For the cons the hardware it came with was basically useless cause when you try to tighten them down it interferes with the 3d printed bracket which was no big deal since i have some hex screws that have a round edge. I also noticed when you try tightening them down you have to be carful not to smash the plastic bracket or it will be deformed. Also wish the lights would point out a little more and maybe even angled better so the cutoff on the light isn’t all miss match even after trying to adjust it but it also could be due to my rock sliders as well. And I do notice that the led doesn’t sit flush on the bracket but I’m just nitpicking. Hopefully there’s a revision in the future for a better bracket but it does the job for now and pretty happy with it for the most part. I also just want to say I have multiple blue dog designwerks parts on my gx470 like the fender extension and rear bumper covers as well as a cup holder insert and all of those held up perfectly and fitment was on point just wish these were made a little bit better.